Home > Shop > Threading
Sort By:
Page of 1
Kit #17R 3/8 inch Threader NV Kit #18 1/2 inch Threader NV Kit #19 3/8 inch Threader (T) Laydown
Contents:
1 bar 3/8 inch shank 4.5 inches overall length
For 8 through 36 pitch 60 degree threading
End pocket: offset for OD threading
1 Insert T-15 High Speed Steel TNMC 32 NV
IC: .375 inch
Thickness: .125 inch
Hole: .150 inch

1 Insert T-15 High Speed Steel TPMC 32 NV
IC: .375 inch
Thickness: .125 inch
Hole: .150 inch
Back rake: 10 degree

Screws: (2) 4-40

Wrench: 1/16 inch
Contents:
1 bar 1/2 inch shank 5.0 inches overall length
Minimum bore: 1.375 inch
For 8 through 36 pitch 60 degree threading
End pocket: offset for OD and ID threading
1 Insert T-15 High Speed Steel TNMC 32 NV
IC: .375 inch
Thickness: .125 inch
Hole: .150 inch

1 Insert T-15 High Speed Steel TPMC 32 NV
IC: .375 inch
Thickness: .125 inch
Hole: .150 inch
Back rake: 10 degree

Screws: (2) 4-40

Wrench: 1/16 inch
Contents:
1 Bar 3/8 inch shank 5.0 inches overall length
TPI: 12
3 Inserts T-15 High Speed Steel TPMW 1.8-1.5-.025
Relief : 11 degree
IC: .218 inch
Thickness: .093 inch
Hole: .100 inch Top opening: .146 inch @ 60 degrees
Radius: .008 inch
Minimum diameter: .502 inch

Screws: (2) CO-2205

Wrench: T-7
Kit #20 1/2 inch Threader (T) Laydown Kit #31 3/4 inch Threader NV
Contents:
1 Bar 1/2 inch shank 6.0 inches overall length
TPI: 10
3 Inserts T-15 High Speed Steel TPMW 2-2-.025
Relief : 11 degree
IC: .250 inch
Thickness: .125 inch
Hole: .110 inch Top opening: .146 inch
Radius: .004 inch
Minimum diameter: .687 inch

Screws: (2) MS-1153

Wrench: T-7
Contents:
1 bar 3/4 inch shank 4 3/8 inches overall length
For 8 through 36 pitch 60 degree threading
Both left and right hand pockets for threading close to the chuck or close to the tail stock
1 Insert T-15 High Speed Steel TNMC 32 NV
IC: .375 inch
Thickness: .125 inch
Hole: .150 inch

1 Insert T-15 High Speed Steel TPMC 32 NV
IC: .375 inch
Thickness: .125 inch
Hole: .150 inch
Back rake: 10 degree

Screws: (2) 4-40

Wrench: 1/16 inch